OSHM4X023 OMP M4 MAX 85A ESC

Description

OSHM4X023 ZTW 85A ESC. Fully programmable, similar to other brand ESC. Multifunction LCD Programmer / LiPo tester / Servo tester available here!

Telemetry supported by Vbar Control, MSH Brain2 / IKON2, Spirit, RotorFlight, and Futaba SBUS-2.

Features

• 85A continuous and 130A peak current support
• High power 10A BEC regulator (6V, 7.4V, 8.4V*)
• Telemetry support: current, voltage, temperature, RPM, throttle and ESC status code.
• Telemetry protocol: Supported by MSH Brain, RotorFlight, Vbar Control and Futaba SBUS-2
• Supports RPM signal over wire. No need for external RPM sensor.

  The ESC has a separate programming interface to connect a LCD programming card or Bluetooth module.

• High performance 32-bit microprocessor running at 170MHz
• New generation MOSFET with low heat generation, large burst current withstanding capability and high reliability.
• Self-check function: after the ESC powers on, it will automatically check for short circuit, motor lose phase, non-zero throttle and battery voltage.

  The specially designed ESC case greatly enhances the ESC’s heat dissipation performance.

• There are two Governor modes: Helicopter Governor Store mode (default) and External Governor mode.
• Multiple protection features: abnormal power-on voltage protection, start up protection, temperature protection, throttle signal loss protection, over load protection,low voltage protection, over current protection.
• Firmware update via OMP Hobby Bluetooth Module using iOS or Android App.

Specifications

• Max Continuous current: 85A
• Max Peak current: 130A
• Input voltage: 3-6S LiPo
• BEC voltage: 6V/7.4V/8.4V
• BEC current: 10A
• Size: 71x36x33 mm
• Weight: 90g

Connectors

• XT60 for Battery
• 3 Bullets for Motor
• 3-pin Throttle Signal Plug: S (Throttle Signal), + (BEC output), – (Ground)
• 1-pin RPM Signal Plug
• 5-pin Programming Header: TX (Transmit), RX (Receive), + (BEC output), – (Ground)

Includes

• ZTW 85A ESC-1